What should I pay attention to when checking the working status in the automatic quantitative packaging scale?

The automatic quantitative packaging scale has a high degree of automation, and its use is also very convenient. The obtained weighing results and packaging quality also meet the requirements. It is a very ideal packaging weighing equipment. However, there are also operators who encounter troubles in the process of using the automatic quantitative packaging scale. For example, the automatic quantitative packaging scale does not make ingredients after it is started. What is the problem?

After connecting the automatic quantitative packaging scale to the power supply and turning it on, pressing the start button found that the machine did not respond, and the packaging scale did not make ingredients. In this case, you may wish to take the elimination method to eliminate the root cause of the fault, so as to take targeted solutions. The first is to check whether the magnetic reed switch on the cylinder of the scale door of the automatic quantitative packaging scale is closed properly. When it is closed, there will be a display on the touch screen. Reed switch, it is enough to lock the reed switch after the display is displayed.

Secondly, check whether the working state of the automatic quantitative packaging scale is automatic. If not, just click the switch to return to normal. Next, check whether the pause button is pressed to self-lock; whether the pause in the manual operation interface of the touch screen is self-locking. If it is self-locking, please switch to the non-self-locking state. If the above is normal, then check whether the air source of the automatic quantitative packaging scale is connected to the packaging scale, whether there is insufficient air pressure, or the air pipe is bent, so that the compressed air cannot reach the cylinder. It is required to turn on the air source and adjust it to the air pressure range, and the automatic quantitative packaging scale can basically work.

Of course, it may also be caused by the fact that the piston rod of the hopper cylinder is not connected, which is related to the long-term multi-frequency action, so it is also necessary to check whether the cylinder piston rod of the large and small material gate of the automatic quantitative packaging scale hopper is disconnected from the material gate. The connection between the cylinder and the material gate can be adjusted to a suitable position.

The fertilizer quantitative packaging machine is specially designed for the quantitative packaging of fertilizer products. Since all aspects are still in the initial stage of development, the technical level of the equipment is not fully mature, and some problems still occur in the actual packaging process. Appropriate improvements to the packaging scale. For example, the material in the bag mouth of the fertilizer quantitative packaging scale has large dust, mainly because the distance between the feeding port of the weighing hopper and the bag holder is relatively large, so that the material generates dust at the mouth of the bag under the action of gravity, and the splashing material affects the labor force. The health of the baggers and the drop of potash fertilizers also increase the workload of the workers.

In order to overcome this difficulty, a secondary cutting device composed of a cutting plate, a cylinder and a solenoid valve is installed between the discharge transition bins of the fertilizer quantitative packaging machine, which not only slows down the gravitational potential energy generated by the falling of materials, but also reduces the The amount of material splashing out can alleviate the pollution and corrosion of the surrounding accessories, and at the same time reduce the failure links of the fertilizer quantitative packaging scale, improve the packaging output, and correspondingly reduce the labor intensity of operators.