Feed processing machinery pay attention to keep the material flow of the feeder stable

The use of packaging scales is still relatively large in peacetime, not only for the weighing of materials, but also for the packaging of materials. In this case, the equipment will automatically turn on after it stops. For this fault, we can basically conclude that there is a problem with the control system of the packaging scale.

Therefore, first check the working status of the terminals of the control cabinet of the packaging scale. If it is closed, it is a problem outside the system. If it is disconnected, it is a system failure. There are two main reasons for the failure of the system itself. On the one hand, the relay board automatically sends a start signal, and on the other hand, the instrument automatically sends a start signal. After the root cause is identified, effective measures can be taken to solve it reasonably.

While ensuring the normal operation of the feed processing machinery, care must also be taken to maintain a steady flow of material from the feeder. For example, a buffer bin can be added above the granulation equipment, which helps to keep the incoming material stable. More importantly, maintaining a reasonable amount of material is conducive to fully improving the production efficiency of the equipment.

In fact, many users have found the problem of low production efficiency, and they are more concerned about the problem of feed processing machinery, but ignore the incoming factor. However, in many cases, the problem of low efficiency is actually mainly caused by the unstable flow of incoming materials.

That is to say, when the feed processing machinery is running stably, keep a sufficient amount of steam, open all the feed gates, and adjust the speed of the feeder to the rated value. When the flow rate of the incoming material is insufficient, it can be judged that the problem of insufficient incoming material flow should be dealt with in time.

During the operation of the feed processing machinery, not only attention should be paid to the control of incoming materials, but also the reasonable selection of ring dies. You know, in fact, in the granulation process, whether the material can be squeezed through the die mainly depends on the pressure and friction that can be generated in the die hole.