Check and ensure that the belt tension of the feed machinery is properly

During the operation of the feed processing machinery, we should provide good lubrication and care for the transmission device, so as to reduce the loss of power during the transmission process. In this way, it is equivalent to achieving the effect of energy saving. In order to achieve this requirement, it is necessary to select the appropriate lubricant and control the amount to ensure that the equipment has a good working environment and condition.

At the same time, it is also necessary to check and ensure that the tension of the transmission belt of the feed machinery is appropriate, and it must be matched with matching pulleys and other devices. In addition, try to avoid vibration problems caused by chain slack and keep the chain at a proper tightness. And pay attention to keep the transmission clean to avoid local excessive heat collection. Another method that can reduce the energy consumption of feed processing machinery is to reasonably control the crushing process. To put it simply, in fact, during the operation of the feed mill, we must pay attention to reversing the hammer in time or replacing the hammer and cloth bag, so as to improve the crushing efficiency. Also pay attention to ensure that the negative pressure of the air assist system is in good condition, thereby increasing production.

In the process of feed machinery production, the crushing of raw materials is a very important link. Therefore, in the daily maintenance work, we should pay special attention to the maintenance and management of the crusher equipment. When overhauling, it mainly includes three important contents. Part of the content is the repair and replacement of the screen.

You must know that if the screen fails, the subsequent processing links will also be affected. Therefore, we need to regularly check the specific conditions of the feed machinery's pulverizer screen. If it is found that it is worn or broken down by foreign objects, it needs to be dealt with in time. Of course, if the damaged area is relatively small, it can be repaired with an appropriate half size.

If it is found that the damage is more serious, then the screen needs to be replaced with a new one. When replacing, we should install the burr side inside, with the smooth side facing out, and make sure that the screen and the screen frame fit tightly. Otherwise, it may affect the discharge effect of the pulverizer of the feed machinery. The main content of the second part is the lubrication and replacement of single-column hydraulic press bearings.

As users, we must ensure that lubrication care is carried out in time after a period of use. Under normal circumstances, after every 300 hours of operation of the crusher of the feed machinery, the bearing should be cleaned. If lubrication is required, an appropriate amount of lubricating oil needs to be applied. If a bearing is found damaged, it needs to be replaced immediately.