The technical content of the automatic quantitative packaging scale is naturally very high

Among various packaging scale products, quantitative packaging scales are mostly used because it can bring users accurate packaging effects. To achieve this goal, in addition to the quality of the equipment, the packaging parameters of the quantitative packaging scale must be correctly set.

The technical content of the automatic quantitative packaging scale is naturally very high, but even so, problems will still occur. Typically, the upper and lower arc doors of the packaging scale will be closed at the same time, thus hindering the normal operation of the equipment. Does the technician have a solution to this problem?

First of all, we must analyze the cause of this failure. On the one hand, it may be caused by the ineffectiveness of the buffer cylinder of the automatic packaging scale, and on the other hand, it has a certain relationship with the length of the weighing time. If the buffer bolt is too short, the buffer cylinder will fail. In this case, the bolt needs to be adjusted to a reasonable position, excluding the microswitch being turned off due to impact after rough feeding.

In addition, when the weighing time of the automatic packaging scale is too long, the material will be blocked due to the inability to keep up with the speed of the upper and lower arc gates, which will slow down the unloading speed. This shows that the weighing time in the packaging process needs to be reasonably controlled, and it should not be too long while ensuring the weighing accuracy. In the process of using the packaging scale, have you encountered various difficult problems, and this is the main problem that plagues users. Today, I have answered the questions raised, I hope it can help you.

If you encounter the phenomenon that the packaging scale does not discharge the material and does not clamp the bag, you must first know whether the bag release switch and the bag clamping switch of the packaging scale are normal. If they are normal, you can also check the cylinder and solenoid valve of the packaging scale. If there is a problem with the two components, it will also reflect the appearance of no bag or no bag.

But what should I do if the feeding door of the packaging scale cannot be closed or opened? The problem may also lie in the cylinder and the control solenoid valve, so strengthening the inspection in this area will help solve the problem. The latter is about the measurement accuracy of the packaging scale, most of which are related to the parameter settings of the packaging scale.