Pay attention to observe the running state of the electromechanical integrated feed machinery

Before using the feed machinery every day, the lubrication should be checked, an appropriate amount of lubricating oil should be added in advance, and the bearing condition should be checked after 500 hours of use. When installing the screen, the burr side should be installed on it. According to the fineness of the crushed material, select sieves with different diameters. In addition, the reasonable design of the feed machinery and the selection of parameters must also be guaranteed to be reasonable.

At the same time, pay attention to observe the operation status of the feed processing machinery. In particular, after a period of use, the dust collector bag should be cleaned or replaced regularly (to ensure that the bag is breathable), and the working condition of the solenoid valve should be checked regularly (to see if it can work normally). Work). In addition, the wear of each wearing part should be checked regularly and replaced in time if necessary.

Also pay attention to the vibration of feed processing machinery. If it is found that the hammers are severely worn and need to be replaced, you should pay attention to weighing to ensure that the weight difference between the two opposite hammers on the two opposite (1800 direction) hammer pin shafts is ≤1g and the two opposite (1800 direction) hammer pins The total weight difference of the hammers on the shaft is ≤2g. If it is found that the screen is seriously worn and needs to be replaced, pay attention to whether the flatness of the new screen and the size of the screen are reasonable, and whether the installation is in place. The correct use of mechatronic feed machinery is closely related to the quality and efficiency of feed output. That is to say, the correct operation and use can properly extend the service life of the feed machinery. As a user, in daily use, we should pay attention to the maintenance and maintenance of the equipment to ensure safe production.

First of all, in order to avoid accidents in the transportation, loading and unloading of feed machinery, it is necessary to check whether the bolts and nuts of various parts are loose, and whether the flat teeth, round teeth and spindle nuts are loose before use, and tighten them in time. Then turn the pulley by hand to check the machine for collision. At the same time, pay attention to check whether the equipment can maintain flexible operation. If there are sundries in the machine, it must be cleaned up. Generally, it is required to make the equipment run dry for a while to confirm that there is no abnormal problem before normal production can be started.

Secondly, in the process of operating the feed machinery, we must pay attention to strictly control the cleanliness of the materials. If there are sundries in the materials, be sure to remove them. It is strictly forbidden for iron stones and other objects to enter the machine, so as not to damage the machine and hurt people. In addition, the receiving cloth bag should have a length of more than 4 meters and a diameter of 0.6 meters. The cloth should not be too dense, and the material should be discharged in time during use to ensure that the cloth bag has sufficient air permeability.

During the operation of the feed machinery, it is also necessary to strictly control the feeding. It should be noted that the feeding should be kept uniform, and the load degree of the power should be paid attention to to avoid choking. When crushing the particles, the feeding amount can be adjusted by the pumping plate regulator. It should be noted that when the wear of one corner affects the work efficiency, the reverse side of the hammer can be turned around (4 groups are adjusted together at a time when turning the head, so as not to cause the rotor to be unbalanced). The replacement hammer should be completely replaced.

Yicheng Network provides service support