What if there is a fault in the packaging process of the packaging scale?

If there is a fault in the packaging process of the packaging scale, first check whether it can be vacuumed normally, and then check whether the heating wire, contactor, relay and other components are in good condition. If there is no problem with these parts, the reason must be elsewhere. It may be that the specifications of the packing belt do not match the equipment, so that the ironing head in the packing scale cannot be completely in place.

It may also be related to the material of the packing tape. If the material does not meet the standard, the performance will be affected, and the packaging process may also be affected. When encountering similar problems, in addition to readjusting the position of the ironing head, the original packing belt should also be replaced to ensure the use of high-quality products. In this way, the packaging scale can work normally again.

When processing the inclined groove of the packaging scale, it is welded according to the size of the design drawing, but it will be found that the polished surface of the formed inclined groove is inconsistent with the sanding surface of the chassis, which affects the aesthetics of the entire equipment. In fact, this problem can be solved with a little improvement.

Mainly in terms of technology, if the template positioning method is used, the chute can be unified, and in addition to a more coordinated appearance, it can also prevent high temperature melting of wires during welding. The improved chute is used on the packaging scale, and the received use effect is better, which is also of great help to improve production efficiency.

In the packaging industry, there are both packaging and weighing equipment for solid materials and equipment dedicated to liquid products. Liquid filling scales are one of them. When everything is normal, it can help us fill and weigh liquid materials quickly and efficiently. Of course, there will be some common error messages in the actual use process, which will affect the accuracy of product filling. How to solve this?

When the liquid filling scale is used, the large and small injection time is too long, which interferes with the accuracy of the ingredients. The solution is to adjust the set value of the large injection. In general, the maximum injection value should be more than 80% of the target value. .

There is also a phenomenon that is often encountered, that is, the unloading process does not stop when the liquid filling scale is in use. This is because the zero value of the equipment is set too small, so that a small part of the material remains in the scale bucket, and the system It will think that the material has not been unloaded and always output the unloading signal. In this case, it is enough to increase the zero area value appropriately.

There is another problem that is just the opposite. The liquid filling scale has not been unloaded, and the unloading hopper has been closed. This shows that the system has not received the output signal of unloading. Therefore, in this case, the zero zone value should be reduced and the delay time of the equipment should be increased.