Speaking of cleaning up the auxiliary equipment in the mechatronic feed machinery

During the operation of the electromechanical integrated feed machinery, some problems will inevitably occur due to the influence of certain factors. We will summarize some of the more common problems to help you analyze the reasons together, and will give possible solutions. Suggestions for reference, hope to help everyone. Let's take a look at the specific content below!

One of the more common problems is that the pulverizer in the feed processing machinery has the problem of material accumulation at the feeding port. The main reason for such a situation is that when feeding, the feeding amount is too large, which causes the processing of the feed pulverizer to be unable to keep up, blocking the screen and the suction pipe. If such a problem is found, the pulverizer should be shut down immediately, and all accumulated materials should be removed, the suction pipe should be unclogged, and then the feed amount of the pulverizer should be readjusted.

The second common problem is that the feed processing machinery makes abnormal noise during operation. Such a problem usually occurs because a large hard substance enters the inside of the equipment, or some parts inside the equipment fall off, resulting in abnormal sound during operation. At this time, the equipment should be shut down in time, and then find out the specific cause and deal with it.

The third problem is that the particle size of the obtained batch material particles is too coarse after being processed by the feed processing machinery. In this case, the screen is usually worn or hit by foreign objects, and holes appear to cause particle sieving, or the screen and the screen edge are not tightly fitted, resulting in screen leakage.

A relatively common problem is that during the operation of feed processing, a large amount of dust appears in the operation workshop. This situation is likely to be due to the fact that the mouth of the dust bag is not tightly sealed, or the joints of the conveying pipe are not tightly sealed, resulting in dust spillage. The parts of the above processing equipment should be checked and dealt with in time.

In order to ensure the normal operation of feed production, we not only need to carry out the correct operation according to the requirements, but also need to clean up some substances left in the field equipment in time. This can ensure that the equipment can maintain a stable operating state. So, how do we clean up the auxiliary equipment in the feed machinery? Let's look at the specific content together.

In fact, when it comes to cleaning the auxiliary equipment in the feed machinery, we can mainly divide it into three parts. Part of it is the cleaning of the permanent magnet cylinder. In fact, the main function of the permanent magnet cylinder is to help remove magnetic substances such as iron and iron filings, so as to prevent these magnetic substances from adversely affecting the quality of the feed, and at the same time, it can also reduce the harm of these substances to the equipment itself. Therefore, we must clean it up in time, otherwise, it is likely to cause damage to the equipment.