Mechatronics feed machinery has a great feature in operation

With the popularization of mechanization in various industries, the demand for feed machinery is constantly expanding, and the requirements for products are also getting higher and higher. But the fact is not so ideal. Due to the influence of various factors, various problems will still occur during the use of feed machinery, which will also have an adverse impact on the development of the entire industry.

At present, the two key aspects of plastic machinery should be its mold and dust collector. Some manufacturers choose inferior molds in order to save costs, but this will affect the operation of the entire equipment due to the shortened service life. Therefore, it is recommended to We choose the feed machinery mould produced by the original manufacturer.

The electromechanical integrated feed machinery has a great feature in operation, which will generate dust-containing gas with a high concentration, so a dust collector must be set up as an intermediate grading treatment equipment. Of course, the choice of the dust collector is also required, especially the design of the dust removal air net, mainly because it is directly related to the energy consumption, working capacity and dust removal efficiency of the dust removal system, and it is also the normal operation of the feed machinery.

The granulator will produce noise when granulating, which will seriously affect the quietness of the working environment, and you do not know that this noise will have adverse effects on the equipment and production, so you are very worried. After consulting the relevant technical personnel, I realized that the abnormal noise of the pellet machine indicates that there is a fault in the equipment, and there are many possibilities, so be sure to check it out and reject it. The editor has listed all possible factors, you can refer to it.

There may be a fault in the bearing of a certain part of the pellet machine, which makes the machine unable to operate normally and accompanied by noise; or foreign matter enters the ring die of the pellet machine, and the ring die is blocked and cannot be discharged smoothly, thus causing Vibration and noise; if the parts of the pellet machine are not adjusted in place, whether there is a deviation in height or left and right, then there will definitely be vibration during the operation of the machine.

In addition, if the large and small gears in the granulator are worn, or the two gears do not match; the various indicators in the granulation process are not correctly grasped, making the raw materials too dry or too wet; the machine structure is unstable, etc., the above These are all factors mentioned in the morning pellet machine noise. After determining the cause, as long as the targeted solution to the fault can alleviate the noise.