新闻资讯

News Center

current position: Home > News Center > Industry News

In the process of using the electromechanical integrated feed machinery to obtain various feed products

2020-01-20 14:53:59
times

At present, in the process of using electromechanical integrated feed machinery to obtain various feed products, the main processing process is: raw materials, raw material preparation, pulverization, batching, mixing, and granulation to obtain finished feed products. It can be seen that after these five processing procedures, the feed raw materials can be processed into finished feed products.


This process has been going on for a long time, and will basically not change in the future. However, the specific processing methods and the feed machinery used are constantly improving and improving.


For example, in the pulverization process of feed machinery, the reason why the raw materials should be pulverized first is mainly because it is more conducive to the digestion and absorption of animals. In addition, in the batching process, it will also directly affect the quality of the feed.


In addition, in the mixing process and the granulation process, the production quality of the feed machinery will be affected to a certain extent. At present, most enterprises choose granulation production. For example, the integrated single machine that combines the extruder and the pellet press can greatly simplify the feed processing process.


In the process of producing all kinds of feed products, the pulverizer can be regarded as one of the important production equipment. However, in actual production, some problems are sometimes encountered. Below we will analyze the common problems of feed machinery mills, and hope to help.


In general, when a tripping problem occurs, it means that there is a short circuit problem in the circuit. For example, the pulverizer of the feed machinery does not trip when it is not turned on, but once it is turned on, the tripping problem occurs. This shows that the short circuit problem is caused by the vibration after the pulverizer is turned on. Therefore, in response to such a situation, we should promptly check whether the door protection and the forward and reverse travel switch lines are normal. If it is found to be loose or aging, it should be repaired in time.


In view of such a situation, the analysis is carried out in combination with the working principle of the pulverizer of the feed machinery. First of all, if the device can be started normally, it means that the control system is normal. However, it suddenly stops during the start-up process, which is likely to be caused by vibration after the pulverizer is turned on. It should be handled with reference to the previous problem.


Under normal circumstances, the magnitude of the current can reflect the load state of the pulverizer of the feed machinery. If there is a problem with the current being large and small, it means that there is a problem with the feeding. However, since the feeding frequency is set to be constant, the current should theoretically remain the same. The reason for such a problem is likely to be caused by the inconsistency between the feeding direction of the pulverizer and its running direction.


Tags

Recently Viewed:

Related products

news.related_news

Leave your valuable suggestions

Submit

Yangzhou Liding System Engineering Co., Ltd

Add: No.20, Innovation Park East Road, Jiangyang Industrial Park, Hanjiang District, Yangzhou City

Tel: 0514-82123948

Mobile: 13805278236  13665278636

Fax: 0514-82123981

E-mail: wbtot@163.com

Website: www.china-leading.com.cn


X

Leave your valuable suggestions

* name

* contact

* content

After receiving your consultation message, we will contact you as soon as possible
Technical Support:YichengNetwork